When you choose to paint wood paneling in the house use high quality products and. Putty any nail holes or other imperfections with spackling compound.
Caulk gaps between the paneling and trim.
Home diy painting how to paint over paneling. In this case you cannot remove the paneling as you will just damage the surface. If any grease or stains bleed through the primer. Then apply a coat of light weight spackle the same way you applied the first coat of spackle.
Paint paneling apply paint in the same way as the primer by painting the grooves first and following quickly with a roller to smooth the surface. Paint on two coats of a high quality oil based primer letting each coat dry once applied. When painting wood paneling sanding is not necessary.
Be careful not to let the brush strokes dry in the grooves before smoothing with the roller. Allow the primer to dry a full 24 hours before painting over it. Apply a thin coat of your paint to all paneling surfaces.
Allow the putty to dry then sand the spackling flush with the surface. A deglosser is wiped onto the paneling acting as a liquid sandpaper so the paint will stick. Once the second coat of primer is dry coat walls with one coat of high quality latex paint and let dry.
If the adjacent trim isn t going to be painted use paintable clear silicone caulking. Here are the steps on how to easily paint wood paneling. If you plan on covering over your wall paneling you should first and foremost inspect the surface.
In some instances you may be able to remove the paneling and paint the walls directly. You can paint over wood without worrying that it is going to peel. When painting for wood paneling choose either a stain blocking latex primer or an oil based primer.
Just ensure the surface is clean. Painting wood paneling is cost expensive and it will give a fresh and bright look to the dull paneling. If you see any small air bubbles in the paneling lines or nail holes give them a quick sand and wipe clean.
Apply a thin coat of primer with a roller. Use a putty knife to best spread the compound over the holes or imperfections. Remove any excess paint that collects in the panel grooves using your brush.
When it dries it will be invisible on the non painted surfaces. However some paneling is installed and stuck on walls using nails and or adhesive tape. When you have decided to start painting make sure that your paneling is made of solid wood.
Home repair expert henry harrison teaches a homeowner how to paint paneling starting with the most important step which is surface preparation. Take care of any drips right away too. Next a primer is applied with a paintbrush and roller.
Apply another coat if needed. Begin at the top and work your way down making sure to cover all the gaps between the panels. Before painting paneling use painter s tape to mask off your mouldings windows doors and ceiling.
Use a brush to fill in any grooves. In most cases two coats of spackle will be sufficient especially if medium or heavy weight was used first. Use spackle to fill dents or nail holes.
Don t worry about the color of the putty it will dry neutral and be covered with paint.