I did some research and came up with three options for adding a shower to a tub. I wanted to avoid ripping out any of that tile that i so painstakingly installed just a month ago.
A bathtub filled with water is extremely heavy so check building codes and framing support before installing the tub.
Installing a shower to a bathtub. Install the ring around the perimeter of the bathtub. How to install a shower head in a bathtub choice number 1 bathtub adapter. For many different reasons installing a shower head onto a bathtub faucet is easier than installing it on a whole new water supply line.
Measure and mark the location for the top of the ledger usually about 1 inch below the first mark. It will usually be suspended from the ceiling. The ring should be located directly above the inner edge of the tub.
Lower the tub into place so that the continuous flange fits against the wall studs and rests on 1 x4 or 2 x4 supports. The key to installing a shower head over a freestanding bath is enclosing the space to minimise splashing. Princeton recess 5 feet left hand drain americast bath tub with integral overflow white https goo gl ns9h3m princeton recess 5 feet right hand drain ame.
How to install a shower adapter for a bathtub faucet in most cases the tub spout is screwed onto a threaded length of galvanized steel pipe that sticks out of the wall which is called a nipple. It may be possible to change the shower into a tub and shower combination if desired. In this video i m installing a shower wall panels that are 100 waterproof.
The deck mounted faucet is off to one side with the handles on the other side of the tub. You ll need a three or four sided ring if the walls around your tub are not covered with waterproof tiles or plastic panels. So there are actually a lot of things to consider about this that s why we will start from the top.
Push the tub into the enclosure and mark the top of the flange on the wall studs with a pencil. Install a shower curtain rod. I bought installation kit online that consist of 3 boards 240 cm x 100 cm eac.
Anchor the tub to the enclosure with nails or screws inserted through the flanges into the studs. Remember bathtubs and shower stalls may require support framing. Standard bathtubs usually measure 60 x 30 x 14 inches so measuring the shower area is the first step.
The first step in installing a tub is to set in place a ledger board that supports the edges of the tub that contact the walls of the tub enclosure. Walk in showers are easier to convert than smaller ones. The layout of our bathtub surround made installing a shower a little tricky.
There are a number of ways to add a tub to your bathroom. It doesn t matter whether the shower is at one end above the taps or in the centre of the bath.